Skip to content

Clear options and a free in-home estimate: (626) 621-3493

La Puente · West Puente Valley · Valinda · West Covina

(626) 621-3493
Installer in a cap presses black flashing tape around a new white vinyl window set in a house wall covered with white building wrap, ladder leaning nearby

ServicesWindow Installation

Window Installation in La Puente

We install windows in new openings, room additions, ADUs and full-frame tear-outs. Every window is set level, flashed against water and sealed against drafts. You get a clear explanation of the work and a written estimate before anything is ordered.

What window installation means here

Window installation is the work of setting a window into framing that is new or fully exposed. That covers a room addition, a garage turned into an ADU, a wall that is getting a new or larger opening, and full-frame jobs where the old frame comes out down to the studs. If you only want to swap old windows inside the frames you have, our Window Retrofitting or Window Replacement pages are the better fit.

The difference matters because an open wall is where water problems start. A window with a nailing fin has to be flashed in the right order so rain runs out and away, not behind the stucco. We do that layering carefully, then set the window square so it opens, closes and locks the way it should for years.

We are CSLB C-17 licensed, the license California issues for glazing work, so the person putting glass in your walls holds the right classification for it.

What's part of every installation

Sizing from the studs
Our numbers come from the header, sill and studs of the opening itself, never from the window that used to sit there. Each unit is built to order, so accurate sizing at the start keeps your schedule from slipping by weeks.
Layered flashing
Self-adhered flashing tape goes on the sill first, followed by the sides and finally the head, each piece overlapping the one below it like roof shingles. Winter rain then sheds outward instead of working its way into the wall cavity.
Shimmed true and square
Shims under and beside the frame bring it level and plumb so the sash glides and the locks meet their keepers. Even a small twist in the frame can cause sticking or leaks at the corners.
Foam and exterior sealant
We fill the gap between the window frame and the wall framing with low-expansion foam, which insulates without pushing the frame out of shape. A bead of exterior sealant closes the seam where the window meets stucco or siding.
Safety glass in the right spots
Code often calls for tempered glass close to doors, tubs, showers and floors. We review every location and specify tempered panes wherever they are needed.
Cleanup and a walkthrough
Packaging and old materials leave with us, the work area gets vacuumed, and you see how each window opens, closes and locks before we head out.

When installation is the right call

  • You are adding a room or an ADU

    New living space needs new windows set into fresh framing. We can work alongside your builder so the openings are ready when the windows arrive.

  • A bedroom needs an egress window

    Sleeping rooms generally need a window large enough to climb out of. If yours is too small, a larger opening and a new window solve it.

  • The old frame is rotted or bent

    When the frame itself is soft, warped or pulling away from the wall, setting a new window inside it just hides the problem. A full-frame install removes it and starts clean.

  • Water stains below a window

    Stains on the drywall or bubbling paint under the sill often point to missing or failed flashing. That is fixed by opening the wall and installing the window properly.

  • You are already redoing stucco or siding

    If the exterior is being opened anyway, it is the best time for full-frame windows with new flashing tied into the new weather barrier.

How a job runs, start to finish

  1. 1

    Free in-home estimate

    We look at each opening, measure, talk through frame and glass options and point out anything that needs attention first. Free in-home estimates come with no sales pressure or obligation. You get a written estimate that lists each window.

  2. 2

    Permit and ordering

    New or enlarged openings usually need a building permit, and we will tell you up front when one is required. Once you approve the estimate, your windows are built to the measured sizes.

  3. 3

    Install day

    We lay drop cloths inside and out, remove any old window and check the opening for rot or damage. Then we flash, set, shim, foam and seal each window. Most homes need only a day or two of work on site.

  4. 4

    Finish, inspect and hand off

    We patch around the frame, clean up and walk you through each window. If there is a permit, the inspection is the last step before the job is closed.

Worker in a navy cap and T-shirt writes measurements on a clipboard beside a worn sliding patio door on a wooden deck, with tools and a ladder nearby

What moves the price

Window installation doesn't have one set price, because every opening is different. The largest differences come from how much of the wall gets opened up and the condition of what sits behind it. Your estimate breaks out each line so the total makes sense to you.

How many windows, and how big
Bigger units and unusual shapes cost more to manufacture and need extra hands to set. Grouping several windows into one order tends to keep the cost per window down.
Framed opening or full tear-out
A rough opening your builder has already framed is the simpler job. Pulling out an old frame adds demolition, cutting back stucco and patching it afterward.
Frame material and glass
Vinyl, fiberglass and aluminum each carry a different price, and dual-pane low-E glass or tempered safety glass raises it. With the long, hot summers around La Puente, upgraded glass often pays off, and our Energy Efficient Windows page walks through the options.
Hidden damage in the wall
Rot, termite damage or missing sheathing must be repaired before the new frame is set. If we uncover something like that, we take pictures, walk you through them and wait for your go-ahead before any added work starts.
Second-story access and permits
Upper-floor windows take longer to stage safely, and permit fees depend on the scope of the job. You'll see both spelled out in your estimate.

Window installation questions

Something not covered here? (626) 621-3493

How is installation different from window retrofitting?

Retrofitting sets a new window inside the existing frame, so the stucco and trim stay untouched. Installation means the opening is new or the old frame comes out completely. We will tell you which one your home actually needs, and if retrofitting does the job, we will say so.

Will you damage my stucco?

On a full-frame install we cut a narrow strip of stucco around the opening to reach the nailing fin. After the window is flashed and set, we patch that strip. Fresh patching may differ slightly in color until the wall is painted, and we will talk about that before work begins.

Do I need a permit?

Enlarging an opening, adding a new one or building an addition usually requires a permit. Swapping windows of the same size often has simpler requirements. We check the scope during your estimate and handle the permit when one is needed.

Can you work with my general contractor on an addition or ADU?

Yes. We share the rough opening sizes your windows need, then schedule installation once the framing and weather barrier are ready. That keeps your project moving and avoids windows that do not fit.

What warranty comes with the windows?

You get a lifetime warranty on windows, including accidental glass breakage. We will go over what it covers when we hand off the job.

Is my property protected if something goes wrong during the work?

We carry $2 million insurance coverage. We also cover floors and furniture near each opening and clean up at the end of every day we are on site.

Planning new windows for your home?

Tell us about the openings and what you are building. We will come out, measure and give you a straight written estimate with no obligation.